BEST EVER PRO-MADE X1

Hard Hat Sun Shade Installation Guide

STEP 1

If using Velcro fasteners, leave both sides of Velcro attached to each other as shown in example photo. Do not pull off protective sticker peel yet.

If you do not plan on using the Velcro fasteners, then pull apart the two sides of Velcro and continue up to step 4.

STEP 2

Start from back of helmet, and anchor elastic band to begin wrapping orange band to brim of helmet.

Make sure sun shade and Velcro are aligned to back of helmet as well.

STEP 3

While anchoring band to back of helmet, pull the rest of the band down to fully wrap it around the entire brim of helmet.

STEP 4

Once sun shade is secure on helmet, adjust the sun shade by pulling the band along the brim to center it into position.

STEP 5

Once happy with the position of sun shade on helmet, start by pulling the  protective sticker peel off the Velcro. You do not need to separate both sides of Velcro.

When protective peel is removed, press the sticky side of Velcro to helmet to secure it in place. Make sure there is enough surface area on helmet for sticker to optimally hold in place.

STEP 6

When Velcro is properly installed on helmet it should look like this example photo.

The Velcro fasteners will securely hold sun shade on helmet without slipping off.